MKN Deep Fat Fryer 7EFRI025XF – Electric

Two work zones at 2 x 12.5 litres give the MKN 7EFRI025XF a combined oil capacity of 25 litres in a relatively compact fryer module. With a total connected load of 12 kW on an electric supply of 380–415 V, it sits in the mid-range for installed power while still supporting simultaneous operation of both vats.

On board, that 12 kW draw and 3 x 20 A fuse protection need to be planned into the galley distribution rather than picked up ad hoc from a spare way in the panel. The 380–415 V rating aligns with typical three-phase shipboard systems, so the fryer can be ordered directly to the vessel’s supply rather than adapted later. At a net weight of 70 kg and a gross shipping weight of 77 kg, foundations and securing to a plinth or flanged feet are straightforward for most galley layouts without special reinforcement.

The twin 12.5 litre tanks allow separation of products and cooking regimes, which matters where allergen handling or flavour transfer is a concern. Because the unit is fully electric, there is no flue run or combustion air to accommodate, but the 12 kW of heat still enters the galley environment and belongs in the HVAC load calculation. Two independent work zones also give some redundancy: one side can remain in service while the other is drained or filtered, so the fryer does not become a single point of failure at peak service.

The construction detail that stands out for marine use is the combination of fully welded seams and an IPX6 protection rating. Fully welded seams remove potential dirt traps at panel joints and simplify compliance with hygiene inspections that focus on cleanability and elimination of open gaps. IPX6 means the housing is protected against high-pressure water jets, so routine galley cleaning with spray wands can include the fryer exterior without concern for water ingress into the electrical enclosure, provided the operating instructions on cleaning are followed.

A hinged lid is standard on this model. That is more than a convenience: in a moving galley it helps to control splashing when the ship is rolling, and when closed between batches the lid reduces evaporative losses from the oil. The hinged design also keeps the lid attached to the fryer, avoiding loose parts that have to be stowed separately when the vessel is at sea.

Build and control

• Hinged lid
• Fully welded seams
• IPX6 IP-rated water protection

This fryer is a good fit where a galley needs two medium-volume frying positions without stepping up to a larger battery of dedicated single-tank units. It is not the right choice for a very small pantry that only needs occasional light frying, where a single-zone fryer with a lower connected load would impose less demand on the electrical and ventilation systems. Ordered under MKN product number 7EFRI025XF.