MKN Deep Fat Fryer 8EFRI012DFLFS – Electric

6 kW of FlexPower heating defines the MKN 8EFRI012DFLFS as a compact electric deep fat fryer that fits into a cooking line without dominating the electrical balance. That rating anchors both the frying performance and the connected load a ship’s switchboard has to carry.

On board, electrical compatibility often decides whether a fryer is viable before basket sizes or options are even discussed. This unit is specified for 380–415 V, 3 N-PE AC/50 Hz with 3×16 A fuse protection, which sits directly in the range many marine distribution systems already provide. With a known 6 kW draw, the superintendent can assign it to an existing section of the galley board and still keep margin for other loads on the same feeder. That makes it a practical choice on refits where the main switchboard capacity and cable routes are already fixed and new consumers must be slotted into what exists.

The IPX6 protection rating addresses the other constraint specific to ship galleys: cleaning is done with water, not with a dry cloth. During washdown the fryer is exposed to spray from the general galley cleaning regime as well as routine splashes during service. With IPX6 the housing and control components are designed to tolerate water projected from any direction under test conditions defined in the standard, so the cleaning team does not have to bag controls or work around sensitive areas. That in turn supports consistent daily hygiene routines, which are a key part of passing inspection in food areas.

From a design point of view, the 6 kW FlexPower rating is also the figure that lands in the HVAC calculation. That energy ends up somewhere in the room, and a galley that already runs close to the capacity of its ventilation and cooling systems needs each appliance load accounted for. Knowing that the fryer tops out at 6 kW allows the designer to model the sensible and latent heat generated by the whole line more accurately than working from nominal ranges or generic assumptions.

The specified 3×16 A fuse protection is the last piece of the electrical picture. It sets a clear requirement for outgoing breakers and cable sizing and avoids guesswork about inrush or diversity factors. For the yard or refit contractor, that means distribution panels and sub‑mains can be detailed before the fryer is delivered, with less risk of late changes once equipment is on board.

Build and control

• IPX6 IP-rated water protection for cleaning with water spray in the galley

This fryer suits a galley that needs a single electric unit on a 380–415 V, 3 N-PE AC/50 Hz supply where 6 kW can be comfortably allocated and hose‑down cleaning is standard practice. It is the wrong choice where the vessel runs a different supply configuration or where the frying station must carry a significantly heavier load than a 6 kW appliance can deliver and more electrical capacity is available. Ordered under MKN product number 8EFRI012DFLFS.