MKN Work Table 10018324 – Optima 850

Four hundred by 850 mm of working surface on a 700 mm high body defines this Optima 850 work table as a narrow module for tight galley runs. At 37 kg net weight it is light enough to manoeuvre during installation, but once fixed into an Optima line it closes off a run with a stable stainless platform rather than a gap.

On a ship, a 400 mm wide table tends to be the piece that makes a cooking block line up with a bulkhead or clears a door swing. The 850 mm depth ties it into the Optima 850 footprint so pots and trays can move across adjacent appliances without ledges or steps, which is the point of using a system line instead of one-off fabrications. Height at 700 mm means the unit sits as a lower section in relation to full-height Optima modules, which matters for visibility and for routing services underneath in a congested galley.

The working surface and body are both specified at 400 x 850 mm, so the plan dimension is fully usable as a landing or light preparation area. Stainless steel 1.4301 (AISI 304) throughout gives a consistent material across top, sides and internal structure, which simplifies welding to neighbouring Optima 850 modules and avoids the mixed-material interfaces that trap moisture. Net weight is 37 kg with a gross shipping weight of 42 kg, so the difference is packaging rather than a separate frame or loose parts.

Because the construction is described as self-supporting and closed, the table can be planned either as a stand-alone section of worktop or as an infill in a continuous Optima 850 suite without needing additional carcassing below. In a marine galley that reduces the number of separate plinths or foundations that have to be sealed to meet hygiene requirements. The compact footprint also makes it a candidate for transitions between cooking blocks and refrigerated counters where only a short neutral section is required.

Build and control

• Stainless steel 1.4301 (AISI 304) throughout
• Self-supporting closed construction

This table is the right choice where an Optima 850 line needs a 400 mm wide neutral element to complete a run or provide a small work section between appliances. It is less suitable where large preparation areas or storage beneath the work surface are required, because the 400 x 850 mm footprint and closed body limit both working width and under-counter volume.

Ordered under MKN product number 10018324.