MKN Work Table 10019121 – Optima 850

1200 x 850 mm of working surface on this Optima 850 table gives a full-size neutral section that matches its own footprint. At 700 mm overall height and 55 kg net weight, it is a solid fixed module rather than a light auxiliary shelf.

On board, the 850 mm width (depth in Optima terminology) lets the table run in line with other Optima 850 bodies, so the working edge is consistent across the block. That simplifies galley planning where equipment sits hard against bulkheads and there is little room to compensate for mismatched depths. The 1200 mm length is long enough to act as a functional preparation, plating or landing area while still fitting into tighter spans where a longer table would not clear doors or structural members.

The dimensional data also matter for installation and logistics. Overall size is 1200 x 850 x 700 mm (L x W x H), with the working surface specified at the same 1200 x 850 mm. There is no reduced usable depth from inset edges or overhangs, so the full plan area can be treated as working space or as a footprint for smaller countertop appliances. Net weight is 55 kg, which is the figure the naval architect needs for deck load and stability calculations. Gross weight is 71 kg, which is the value to use when planning handling, crating and lifting during the yard phase.

Material specification is stainless steel 1.4301 (AISI 304) throughout. Using one austenitic stainless grade for the top and structure avoids mixed-material joints and keeps cleaning practice straightforward, as all exposed surfaces respond the same way to the detergents and sanitising agents commonly used in galleys. In the context of an Optima 850 line this helps maintain a consistent visual and hygienic standard across cooking and neutral sections.

Where a designer is working within the Optima 850 series envelope, the 1200 x 850 mm working surface gives a clear module that can be repeated or alternated with cooking appliances to build up a continuous run. In a refit where the existing galley is already set out on 850 mm bodies, this table can often drop into place without revising bulkhead penetrations or service distribution, because its plan size follows the same pattern.

Build and control

• Stainless steel 1.4301 (AISI 304) throughout
• Self-supporting closed construction

The unit is a good fit where the galley layout is based on Optima 850 bodies and a 1200 mm-long neutral section is needed between or beside cooking equipment. It is the wrong choice where the line is built around a different body depth or where the only available span is shorter than 1200 mm, because the 1200 x 850 x 700 mm envelope cannot be reduced or adjusted on site. Ordered under MKN article number 10019121.