Miele Rotary Ironer PRI 210 [EL SOM STW AB] – 3 AC 440V 50-60HZ, Iron grey

Thirty kilograms per hour at 15% residual moisture on a 1,000 mm working width defines the PRI 210 as a compact flatwork ironer for shipboard laundries. With a 210 mm roller diameter and a controlled speed band from 1.5 to 4 m/min, it is sized to process crew and small guest linen streams without demanding the footprint or electrical load of the largest flatwork machines.

The electrical connection is specified as 3 AC 440V 50–60HZ, which aligns directly with a typical marine switchboard feed. Total connected load is 5.8 kW with a 5.4 kW electric heater rating on a 16 A fuse rating, so the unit can often sit on an existing laundry sub-board without redesigning the distribution. Maximum floor load is 1,220 N at a net weight of 122 kg; that published figure lets the yard confirm deck scantlings early instead of treating the laundry as residual space.

External dimensions are 1,579 mm in width, 1,032 mm in height and 476 mm in depth. That shallow depth allows the PRI 210 to stand against a bulkhead while leaving a clear working corridor in a narrow laundry. Gross dimensions of 1,763 × 1,374 × 660 mm and a gross weight of 136 kg are quoted for transport and installation planning, from loading bay through lifts and stair cores to the final position on board. Heat dissipation into the room is 4.5 MJ/h and the emission sound pressure level at the workplace is given as ≤70 dB(A) re 20 µPa, both important when the laundry adjoins accommodation or when HVAC margin is limited.

Padding is specified as supple steel wool with an ARAMID needle-felt cloth as the ironer cover. This stack is engineered for the PRI 210’s duty profile and contributes to the quoted 20,000 tested operating hours. A recycling rate of 98% is stated, which becomes relevant at refit or decommissioning when equipment disposal cost and material recovery enter the calculation.

Operation is via a touch display control system, with programme setting through defined programme parameters. Minimum and maximum ironing speeds between 1.5 and 4 m/min are set from the same interface, allowing the superintendent to standardise settings across shifts and vessels where identical models are installed. Outer casing colour is iron grey, which may help blend the ironer into an enclosed laundry where open sightlines from passenger areas are a concern.

Build and control

• Specified for offshore installations
• Specified and approved for shipboard use
• Prepared for a payment system (self-service laundries)
• Touch display control system
• Programme setting with defined programme parameters
• Supple steel wool padding with ARAMID needle-felt cloth ironer cover

The PRI 210 is a good fit where a vessel needs an electrically heated, 3 AC 440V 50–60HZ ironer delivering up to 30 kg/h in a narrow room with limited available depth. It is the wrong choice where very wide table linen dominates the workload or where peak flatwork demand significantly exceeds 30 kg/h, as those cases call for a longer working width and a larger-capacity ironer in the same range. Ordered under Miele material number 11741300, article number 53210008SOM, designation PRI 210 [EL SOM STW AB].