Electrolux Professional Deep Fat Fryer 371164 – 900XP, 700XP Two Well Freestanding Electric Fryer 2x14 liter

Two 14 litre wells on a single chassis and 17.4 kW of installed power set the 371164 up for continuous deep‑fat work in a compact footprint. Each well is usable between 12 and 14 litres, which is the range that keeps the elements covered and the oil turnover predictable.

On board, the 380–400 V/3 ph/50/60 Hz supply specification allows this 900XP fryer to sit on the same distribution as other galley equipment without a transformer. Electrical loading at 17.4 kW needs to be accounted for in the panel schedule and in the air‑conditioning calculation, because that power ends up as heat in the galley air once the baskets cycle. IPX4 gives protection against splashing water, which suits manual hose cleaning, but it still needs to be positioned so that direct high‑pressure jets are not aimed at the controls.

The wells measure 240 mm wide, 380 mm deep and 285 mm high, so the usable basket area is rectangular and easy to load consistently. That geometry matters when planning standard portions and basket sizes; a galley can match baskets to the 240 mm width and 380 mm depth to avoid dead zones and uneven frying. Net weight is 81 kg, with a gross shipping weight of 85 kg and a quoted shipping volume of 0.8 m³ at 1140 × 820 × 860 mm, so moving the unit into the vessel and through doorways can be planned from the drawing rather than guessed on the quay.

The thermostat band from 105 to 185 °C gives enough span for blanching, finishing and holding without overshooting the upper oil limits stated in most shipboard HACCP plans. The lower end allows lower‑temperature work where product or process demands it, while still staying hot enough to avoid long recovery times after loading. The two wells share the electrical headroom, so they can be run together or independently depending on service.

Build and control

• IPX4 rated against water ingress
• Scotch-Brite finished exterior panels
• Flush-fitting side edges for gap-free installation
• Rounded internal corners for cleaning
• Adjustable feet
• Overheat cut-out

Flush-fitting side edges mean the 371164 can be butted against adjacent 900XP modules without gaps, which removes soil traps between appliances on a line. Rounded internal corners in the wells help cleaning crews turn around the fryer between services without chasing debris out of tight angles. The overheat cut-out protects the elements and oil in the event of low level or control fault, which is a straightforward safety point in a busy galley.

This model is a good fit where two oil types or two simultaneous frying temperatures are required in a single 900XP position, and where the vessel already runs a 380–400 V/3 ph/50/60 Hz system. It is not the right choice for a very small galley that only ever needs one fryer well; in that case a single‑well body frees up line space for other functions.

Ordered under Electrolux Professional product number 371164.